NetCMD

Description

netcmd is used  to perform an arp spoofing attack to redirect traffic through the attacker.

Usage

Syntax

netcmd [options]

Options

  -h, --help            show this help message and exit
  -I IFACE, --iface=IFACE
                        Network interface to use if different from the default
                        one.
  -N NETWORK, --network=NETWORK
                        Network to work on.
  -G GATEWAY, --gateway=GATEWAY
                        Gateway to use.
  -K, --kill            Kill targets connections instead of forwarding them.
  -D DELAY, --delay=DELAY
                        Delay in seconds between one arp packet and another,
                        default is 5.
  -A, --all             Keep spoofing and spoof all connected and later
                        connected interfaces.

Example

cyborg@cyborg:~$ sudo netcmd 
[sudo] password for cyborg: 

	NetCommander 1.3 - An easy to use arp spoofing tool.
 	Copyleft Simone Margaritelli <[email protected]>
 	http://www.evilsocket.net
	http://www.backbox.org

@ Searching for the network gateway address ...
@ Gateway is 192.168.1.1 on network 192.168.1.0/24 .
@ Searching for alive network endpoints ...
@ Please choose your target :
  [0] 74:de:2b:c3:a0:2f 192.168.1.2
  [1] 10:78:d2:2b:8f:e1 192.168.1.40
  [2] f8:2f:a8:c3:e5:f1 192.168.1.7
  [3] d8:3c:69:76:09:96 192.168.1.8
  [4] c8:f7:33:77:1a:be 192.168.1.18
@ Choose [0-4] (* to select all, r to refresh): 0
@ Enabling ipv4 forwarding system wide ...
@ Spoofing, launch your preferred network sniffer to see target traffic ....
0 Comments

Leave a reply

CONTACT US

We're are building as a community and a team. Be a part of it.

Sending

©2018 Ztrela Knowledge Solutions Pvt. Ltd

Log in with your credentials

Forgot your details?